Tuesday, May 11

This stuff ain't for wimps


I know you all are ever so impressed with my happy Harriet homeimprovementmanship. However, in the interest of full disclosure, I have to tell you this story:

So I bought these big tubs and pots for the deck a few weeks ago. I got a couple of kinds. One doesn't drain very well, I discovered, so I figured I would just drill some extra 'drainage'. I get out the drill and it's cordless so I charge it for a few hours on Saturday while I'm doing something else. Then Saturday afternoon I slip a drill bit in and tighten it up real good using something called, I kid you not, a "chuck key." Mind you, the tub is full of dirt and a few plants at this point so I have to be very careful about tipping the pot in order to get at the bottom. Well, I do this and find a way to prop it while I drill and it's all good, except I'm finding that the bit is only barely marking the plastic tub (did I mention it was plastic? Made to look like wood, but not). So I figure probably there isn't enough power and decide to recharge overnight and try again on Sunday.

Sunday I recreate the tipping of the pot and put the bit back in, use the chuck key to tighten it up, and give it a few experimental whirls.

I try again to drill a hole in this plastic tub and again all I accomplish is to scrape a few curls of plastic off. I'm impressed with how well made this thing is. Maybe I'm using the wrong kind of bit? There are bits for drilling different materials, I know; I don't know how to tell them apart. So I go and look and select one that is, at least, different from the one I'm currently using. Replace the old bit -I'm getting good with the chuck key - and try again. Still nada. And I'm thinking, is this thing made of plastic-coated titanium? My frustration level is rising. I try a different place on the pot, same thing. Maybe I need more pressure? I brace the pot and try putting a little muscle into it. Still no results.

I've been sitting there on the deck trying to put a *&^%$ hole in the *&^*%* pot for 20 minutes and at this point I'm considering using the &^%$& drill as a blunt instrument and hammering a &^%$& hole in the thing. Then, as I'm looking at the drill bit and giving it a few more experimental whirls, fuming over what should have been a really easy 5 minute project, I notice that the threads on the drill bit appear to be going in the wrong direction, spiraling up into the drill, instead of down into the still nonexistent hole. Huh.

Turns out, the drill has TWO DIRECTIONS. One for drilling in to a surface, and one for extricating the bit from the resulting hole. And if you have it going the wrong way, there ain't no way you're going to make a hole in anything thicker than paper.

I timed it. I put 10 holes in the bottom of that pot in 4 minutes. It only took me two days.

3 comments:

Lou said...

Don'cha just hate it when that happens??

The Merry said...

I love a parade,the tramping of feet

Lisa Deon said...

For I love a parade.